$ sudo smartctl -a /dev/sdc smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-66-generic] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Vendor: SEAGATE Product: ST14000NM0001 Revision: K001 Compliance: SPC-5 User Capacity: 7,000,259,821,568 bytes [7.00 TB] Logical block size: 4096 bytes LU is fully provisioned Rotation Rate: 7200 rpm Form Factor: 3.5 inches Logical Unit id: 0x6000c500a7b3ceeb0000000000000000 Serial number: ZKL00CYG0000G925020A Device type: disk Transport protocol: SAS (SPL-3) Local Time is: Sun Mar 21 15:00:00 2021 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled Temperature Warning: Disabled or Not Supported === START OF READ SMART DATA SECTION === SMART Health Status: OK Grown defects during certification Total blocks reassigned during format Total new blocks reassigned Power on minutes since format Current Drive Temperature: 28 C Drive Trip Temperature: 60 C Manufactured in week 26 of year 2019 Specified cycle count over device lifetime: 50000 Accumulated start-stop cycles: 498 Specified load-unload count over device lifetime: 600000 Accumulated load-unload cycles: 553 Elements in grown defect list: 0 Vendor (Seagate Cache) information Blocks sent to initiator = 150743545 Blocks received from initiator = 964465354 Blocks read from cache and sent to initiator = 1014080851 Number of read and write commands whose size <= segment size = 8318611 Number of read and write commands whose size > segment size = 12 Vendor (Seagate/Hitachi) factory information number of hours powered up = 264.67 number of minutes until next internal SMART test = 48 Error counter log: Errors Corrected by Total Correction Gigabytes Total ECC rereads/ errors algorithm processed uncorrected fast | delayed rewrites corrected invocations [10^9 bytes] errors read: 0 0 0 0 0 35801.805 0 write: 0 0 0 0 0 3951.501 0 Non-medium error count: 0 No Self-tests have been logged